Description:
Bituminous Flashing Tape is a Self -Adhesive tape made of a Butyl & Bitumen Rubber Compund, Self Protected by re-enforced Aluminum
Foil on one side and Adhesive side is protected by Release Film. Flashing Tape is a simple yet highly effective solution for waterproofing, sealing and insulation.
Features
* Provides an instant seal
* Easily applied by hand pressure only
* Safe application , no pollution
* Available in wide range of widths, thickness, colors
Usage
* Replacement or repair of flashing
* Guttering, down pipes, skylights
* Extensions, porches, window frames
& chimneys, jointing for artificial grass
* Caravans & Conservatories
* Sealing parapets, valley gutters
* Seals capping bolts & roof ridges
* Roof repair of portable buildings
Application
The application temperature should be between 5℃ to 45℃. The installation procedures are to be as follows:
- Unroll only the required length and cut the pieces to the desired shapes and size.
- Place the pieces of membrane on the area to be covered and check whether they match will the profile of the marked substrate.
- Peel off the release film and carefully place the membrane so as to ensure a minimum of 50mm overlap and then smoothen the membrane from the centre to the edges in order to dive out entrapped air
Technical data
| Property |
Data |
Test Method |
| Thickness |
1.0mm, 1.2mm, 1.5mm |
- |
| Backing type |
Aluminum foil, HDPE film |
- |
| Adhesion to Primed Concrete |
＞ 250N |
ASTM D 1000 |
| Adhesion to Steel |
＞ 250N |
ASTM D 1000 |
| Elongation % |
＞ 30 |
BS 2782 |
| Tension N/50mm |
＞ 200 |
- |
| Temperature Resistance |
-25℃ /+90 ℃ |
- |
Packing
Available in 50 mm,75 mm,100 mm,150 mm,200 mm,225 mm,250 mm,300 mm rolls of
2.5 m,3.0 m, 5.0 m,1 0m,20 m length
Special sizes made to order
