Description:

Bituminous Flashing Tape is a Self -Adhesive tape made of a Butyl & Bitumen Rubber Compund, Self Protected by re-enforced Aluminum
Foil on one side and Adhesive side is protected by Release Film. Flashing Tape is a simple yet highly effective solution for waterproofing, sealing and insulation.

 

Features

* Provides an instant seal

* Easily applied by hand pressure only

* Safe application , no pollution

* Available in wide range of widths, thickness, colors

 

Usage

* Replacement or repair of flashing     
* Guttering, down pipes, skylights
* Extensions, porches, window frames

& chimneys, jointing for artificial grass
* Caravans & Conservatories
* Sealing parapets, valley gutters
* Seals capping bolts & roof ridges
* Roof repair of portable buildings

 

Application

The application temperature should be between 5℃ to 45℃. The installation procedures are to be as follows:

• Unroll only the required length and cut the pieces to the desired shapes and size.
• Place the pieces of membrane on the area to be covered and check whether they match will the profile of the marked substrate.
• Peel off the release film and carefully place the membrane so as to ensure a minimum of 50mm overlap and then smoothen the membrane from the centre to the edges in order to dive out entrapped air
•  

Technical data

Property	Data	Test Method
Thickness	1.0mm, 1.2mm, 1.5mm	-
Backing type	Aluminum foil, HDPE film	-
Adhesion to Primed Concrete	＞ 250N	ASTM D 1000
Adhesion to Steel	＞ 250N	ASTM D 1000
Elongation %	＞ 30	BS 2782
Tension  N/50mm	＞ 200	-
Temperature Resistance	-25℃ /+90 ℃	-

 

Packing

Available in 50 mm,75 mm,100 mm,150 mm,200 mm,225 mm,250 mm,300 mm rolls of

2.5 m,3.0 m, 5.0 m,1 0m,20 m length

 

Special sizes made to order